Add to wishlist

Cool PCB Fan holder 80mm

kr.69,00 Inkl. Moms

Indeholder :
Plastik holder til universal montage af 80mm blæser/fan

Varmebestandig plastik som kan holde til sollys.

Add to wishlist
Varenummer (SKU): Fanholder 80mm artic Kategorier: , , Brand:

What a cool PCB

Do you know the problem many gets after installing a high preforming elektronic like an audio amplifier in their car or living room, its just like when
installing a hot wood stove in the log cabin or your tent, and the heat gets to you and your electronics.
Thats hooot. and its going to ruin your day, if the temperature is not tempered, then you are also not with a good temper.
And a bad temper can become pretty expensive, especially if the audio electronics burn up because of too little coooling on the PCBs.

Stay Frosty with the newly developed Cool PCB kit, that keeps your electronics and yourself, or your wood stove cooler than ever.
And automatic.

We made it easy, you can do it yourself, or you can buy the kit in pieces and assemble it yourself.
iF you are not into software, and coding, or the soldering thingy but just want a piece that works out of the box..
Buy or own hand produced full kit, then you only have to plug in the power, and the fans pwn plugs to the board and you are finished.

100% fully automatic cooling, that shuts down when the temperature is low enough, so you are not kept awake, or disturbing your low volume music.
Regulates RPMs in steps from pre determined temperature steps. Until your electronics go in the freezer..

Developed in Denmark.
Hand assembled also in Denmark.
Stay Frosty.

Vægt 0,5 kg

Her starter din rejse hvis du ønsker at få automatisk trinvis PWM køling efter temperatur.
Og du ønsker at gøre det helt selv, evt skaffe delene selv.
Hermed et Cool PCB shield som du kan bygge fra.
Enten med egne dele, eller med vores dele.
Ønskes vores software, skal du købe vores færdige kit eller en arduino fra os, med software på.

Fyld pcb Shieldet ud med de produkter som er noteret på det og byg en blæser styring som er trinløs.
“du kan ikke se dem på billedet” men de er printet på det endelige pcb du modtager.
Det er for 100% gør det selv folk med forståelse for microprocessor teknologi.

This is where your journey starts if you want to get automatic step-by-step PWM cooling according to temperature.
And you want to do it all yourself, possibly get the parts yourself.
Here with a Cool PCB shield that you can build from.
Either with your own parts, or with our parts.
If you want our software, you must buy our finished kit, or a standalone coded Arduino along with the pcb.

Fill out the pcb Shield with the products listed on it and build a fan controller that is stepless.
“you can’t see them in the picture” but they are printed on the final pcb you receive.
It is 100% do it yourself people with an understanding of microprocessor technology.